Skip to content
Lance's Workbench

Lance's Workbench

Where life and progress is slower, but satisfying

  • About Me

Category: Boxes

October 30, 2019 Boxes

Boxes #8 and #9 – Half blind dovetail practice

I’ve been thoroughly enjoying learning to do dovetails, and in order to accelerate my learning, I thought I’d prepare a

Continue reading
September 18, 2019 Boxes / Projects

Box #7 – A plain plane box

I purchased and refurbished a Stanley # 4 1/2 plane for my brother’s birthday. There were too many sharp angles

Continue reading
August 2, 2019 Boxes / Projects

Box #5 & #6 – Card boxes

My wife is visiting her aunt and uncle in Germany at the moment. Her aunt and uncle have had a

Continue reading
May 7, 2019 Boxes / Projects

Boxes #2 & #3: The Sisters

I made Box #2 to practice adding splines. At the same time some friends had a baby. As a family,

Continue reading
May 7, 2019 Boxes / Projects

Box #1: A box for treats

I’ve been really struggling to get my mitred corners nice and tight, so decided the best solution was to not

Continue reading
May 7, 2019 Boxes / Projects

Box #4: A box for Mom

I wanted to make a special box for my Mom’s birthday. It took lot longer than I had indented, but

Continue reading

Categories

  • Boxes (6)
  • Musings (7)
  • Projects (21)
  • Tools (28)
    • Shop made (5)
  • Uncategorized (1)
  • Work Bench (6)
  • Workshop (1)

Archives

  • November 2020
  • June 2020
  • May 2020
  • April 2020
  • March 2020
  • December 2019
  • November 2019
  • October 2019
  • September 2019
  • August 2019
  • May 2019
  • April 2019

Recent Posts

  • Hanging wall cabinets – forging individual history into a combined future.
  • Attempting to [CTRL]+Z a half blind draw-bored mortice and tenon
  • Restoring an early 80’s Woodfast Lathe
  • Finding the Toyota Camry of Sliding Bevel Gauges
  • Paul Sellers’ plane pull test

Recent Comments

  • Roger Hardie on Attempting to [CTRL]+Z a half blind draw-bored mortice and tenon
  • Finding the Toyota Camry of Sliding Bevel Gauges – Lance's Workbench on Sliding Bevel Gauges – The impossible tool?
  • Lance on The plan to make a plane
  • Fiona Verdouw on The plan to make a plane
  • Lance on Plugging leaks (or how to stop blood going everywhere)

Subscribe to Blog via Email

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

WordPress Theme: Maxwell by ThemeZee.